Magnetic pump installation matters


Magnetic driven pump (magnetic pump for short) is a new product which applies the working principle of permanent magnet coupling to centrifugal pump. Reasonable design, advanced technology, full seal, no leakage, no corrosion.
Magnetic pump is widely used in petroleum, chemical, pharmaceutical, electroplating, environmental protection, water treatment, film and television printing departments to pump flammable, explosive, toxic, valuable liquid. It has extensive sealing, no leakage and corrosion resistance. It is the ideal pump to create a leak-free, pollution-free civilized workshop and civilized factory.
The following should be considered when installing the magnetic pump:
1. Place the equipment on the foundation, place a pair of wedge pads between the bottom plate and the foundation, and then adjust the pump level by adjusting the wedge pads. After adjustment, tighten the anchor bolt.
2. Check the pump and motor before installation. All parts should be intact. There should be no debris in the magnetic pump.
3. Make the concrete foundation according to the basic size and embed the anchor bolts at the same time.
4. The suction and discharge pipeline of the magnetic pump shall have a support, which shall not be supported by the magnetic pump. The diameter of the inlet and outlet tubes shall be the same as that of the inlet and outlet of the pump.
5. After installation, finally turn the electromagnetic pump coupling by hand to check whether there is friction.
6. Magnetic pump is prohibited to extract the medium with particles, and easy to crystallize. Continuous operation with outlet closed is not allowed and minimum flow should be maintained.
7. To prevent debris from entering the electromagnetic pump, filter should be installed at the inlet, the filtration area should be 3 to 4 times larger than the cross-sectional area of the pipeline.
8 when the medium viscosity is too high, the electromagnetic pump performance and power will change. For more information, follow the instructions.
9. It is necessary to ensure that the mounting height of the electromagnetic pump conforms to the NPSH of the pump, taking into account the loss of the pipeline and the temperature of the medium.

China vacuum pump suppliers
Vacuum pump for printing machine
Vacuum pump price list
Vacuum pump in vacuum packing machine

评论

发表评论

此博客中的热门博文

Reasons and Solutions for Fragile Belt of Roots Blower

图片
1. Reasons for easily broken belt of Roots blower: 1. First of all, consider the high speed and high temperature of Roots blower. 2. The distance between the head and motor of Roots blower is too large and the belt is tight. 3. The belt does not match the V groove of the pulley, so it can not withstand the load fracture after wearing. 4. Active pulley and driven pulley are not parallel, resulting in serious friction between belt and groove on one side, and can not bear load fracture after wear. 5. Heavy load, long-term overload operation of belt is easy to break. 6. Roots fan nose and motor pulley are not concentric, different axes. 7. Belt quality problems. 2. Measures to prevent the belt of Roots blower from breaking. 1. Roots blower must start without load before running. After starting, it should be loaded. After running, it can generally avoid triangular belt breaking. 2. The pulley between the motor and the fan should be parallel, which is a key point. If not para
阅读全文