How to purge the screw vacuum pump


The screw vacuum pump is an air pumping device that USES a pair of screws to perform reverse rotation at the same pace in the pump shell to provide suction and exhaust functions. It can be applied in the field with more dust. Therefore, it is a basic job to carry out purging of the screw vacuum pump
How to purge the screw vacuum pump
I. cleaning and purging
Screw vacuum pump cleaning purge is mainly used to remove corrosive, harmful or thick substances, such as: tree esters.
Clean and purge usually before stopping the pump, turn off the gate valve of the inlet of the screw vacuum pump, and run it for 20 ~ 30 minutes after filling the inlet with hydrogen or water steam, to purge the screw vacuum pump cavity screw, and clean the residual process steam or thick adhesive material on the surface of the cavity.

Refrigeration purge
Refrigeration purge is used to refrigerate the inner cavity of the screw stator and screw vacuum pump.
Screw vacuum pump, air inlet into the process of gas absorption as the rotation of the screw of the stator is narrow and sent to the air outlet, shrinking process RGL body temperature rising, this needs to maintain with refrigeration purging screw vacuum pump is not due to overtemperature stuck dead gas will be used for refrigeration and scavenging substances, but under special conditions with hydrogen or cooling process after gas purging material. A filter is installed around the outlet of the screw vacuum pump to absorb gas to maintain the cooling purge.

3. Sealing blow
Sealing purge is to use hydrogen gas to pressure the back end cover of the screw vacuum pump to prevent the process steam or liquid from entering the engine cover with tooth shaft and bearing shaft.

Dry screw vacuum pump for high purity vacuum process
Vacuum system is used in brick and tile industry
Rotary vane vacuum pump in cutting machine
Roots vacuum pump in plasma cleaner

评论

发表评论

此博客中的热门博文

Reasons and Solutions for Fragile Belt of Roots Blower

图片
1. Reasons for easily broken belt of Roots blower: 1. First of all, consider the high speed and high temperature of Roots blower. 2. The distance between the head and motor of Roots blower is too large and the belt is tight. 3. The belt does not match the V groove of the pulley, so it can not withstand the load fracture after wearing. 4. Active pulley and driven pulley are not parallel, resulting in serious friction between belt and groove on one side, and can not bear load fracture after wear. 5. Heavy load, long-term overload operation of belt is easy to break. 6. Roots fan nose and motor pulley are not concentric, different axes. 7. Belt quality problems. 2. Measures to prevent the belt of Roots blower from breaking. 1. Roots blower must start without load before running. After starting, it should be loaded. After running, it can generally avoid triangular belt breaking. 2. The pulley between the motor and the fan should be parallel, which is a key point. If not para
阅读全文