How to make the water ring vacuum pump realize automatic water absorption?


Automatic water absorption, first to have the power to help the water absorption tool to achieve this process, for the water ring vacuum pump, we can also use the following methods to achieve its automatic water absorption:
1, water ring vacuum pump water storage can be placed near the pump, and make the bottom of the barrel slightly higher than the pump outlet; Or when a pool is built on the side near the pump room, the pool is lowered slightly to form a reservoir. Connect the bucket with the water filling hole in the pump body with a pipe. Before stopping the machine, fill the bucket with the water from the outlet pipe, and then automatically absorb water when starting next time.
2. Remove the muffler of the small engine and install a special waste drinking water device by using the exhaust gas of the engine to extract the air, so that the water ring vacuum pump can generate a certain vacuum degree. Operation, first start the engine, and then water waste water device handle down deposit, close the exhaust outlet, exhaust gas from the engine, through the exhaust gas jet speed is high, low pressure, thus producing suction effect.
3. Install a cylindrical water tank in front of the water ring vacuum pump, the top of which is hemispherical and protruding. A section of straw is installed in the middle of the cabinet.
The above several methods, can realize the water ring vacuum pump automatic water absorption, are using very simple physical knowledge, can be completed.

Vacuum pump for vacuum preservation
High pumping speed screw vacuum pump
Vacuum pump for alcohol concentration in the food industry

评论

发表评论

此博客中的热门博文

Reasons and Solutions for Fragile Belt of Roots Blower

图片
1. Reasons for easily broken belt of Roots blower: 1. First of all, consider the high speed and high temperature of Roots blower. 2. The distance between the head and motor of Roots blower is too large and the belt is tight. 3. The belt does not match the V groove of the pulley, so it can not withstand the load fracture after wearing. 4. Active pulley and driven pulley are not parallel, resulting in serious friction between belt and groove on one side, and can not bear load fracture after wear. 5. Heavy load, long-term overload operation of belt is easy to break. 6. Roots fan nose and motor pulley are not concentric, different axes. 7. Belt quality problems. 2. Measures to prevent the belt of Roots blower from breaking. 1. Roots blower must start without load before running. After starting, it should be loaded. After running, it can generally avoid triangular belt breaking. 2. The pulley between the motor and the fan should be parallel, which is a key point. If not para
阅读全文