Leak detection using helium mass spectrometer in vacuum furnace?

评论

发表评论

此博客中的热门博文

Variable pump pressure adjustment steps

　　1) Adjust the pressure of unloading valve DA10, relief valve DB10 or DB20 to the minimum. 　　 2) Check in the slurry inlet valve and close the slurry outlet valve to the minimum, that is, the slurry flow rate of the pump is small at this time. 　　 3) Start the motor, slowly adjust the relief valve DB10 or DB20 to adjust the mud pressure to be about 0.1Mpa-0.2Mpa less than the required pressure. 　　 4) Slowly adjust the unloading valve DA10 until the unloading valve has pressure (that is, the pressure gauge corresponding to the unloading valve shows less than 0Mpa). 　　 5) If the state cannot be reached, adjust the unloading valve and the relief valve according to the above steps 3 and 4 until this state. 　　 6) After adjusting the unloading valve, tighten the nut. (Note: The pressure of the unloading valve should be zero at this time, if it is not zero, then slightly lower the pressure of the unloading valve, and the pressure will only be displayed when it reaches zero). 　　 ...
阅读全文

Reasons for Axis Breakage of Water Ring Vacuum Pump and Corresponding Measures

图片
Axis Breakage of Water Ring Vacuum Pump: After 2 years of use, water ring vacuum pump will present the phenomenon of excessive noise, excessive starting current, remarkable decrease in pumping capacity and vacuum degree. It is found that the scale inside the pump body is severe after the technical staff of our company disassembled and inspected. The reason for scaling is that the water contains calcium, magnesium and other carbonate substances. When the pump is heated and heated, its solubility decreases, and molecule-bound deposits form scales. What measures should be adopted to avoid axle breakage? Water ring vacuum pump Through the analysis of the causes of shaft breakage of water ring pump, the following corresponding measures are adopted. 1. Revamping the original process equipment to reduce the content of impurities in acetylene gas trap: At the same time, the large well water of water ring vacuum pump is changed into circulating water to reduce the hardness of wat...
阅读全文

Improvement of oil circulation structure of rotary vacuum pump

图片
Based on rotary vane vacuum pump oil seal type something in industry application, makes the general rotary vane vacuum pump oil seal type medium vulnerable to pollution, emulsification and failure, still can cause oil hole plugging and exhaust valve damage, resulting in waste of oil pump, pump maintenance rate increased pump damage, even cause significant cost burden to users. If switch to other types of vacuum pump, such as slide valve pump, water ring pump, oil ring pump or dry pump, or the same results, or the performance can not meet the requirements or the cost can not afford. In view of the above situation, the oil circulation structure of the general oil-sealed rotary vane vacuum pump has been greatly improved. The oil of the existing general oil-seal rotary vacuum pump is discharged from the exhaust valve and then directly enters the pump chamber again. When the pump stops, the oil is easy to return into the pump chamber, causing the next start difficulty and oi...
阅读全文